為防止銅欄桿等銅飾品生銹氧化變色，可以使用紫銅件耐鹽防銹防氧化變色高透明納米液晶液，銅欄桿廠家下面介紹其使用方法：
一、用途：
在環溫-40-+60℃條件中能快速浸入紫銅件淺表層內極化結晶，使其在海水中、海洋氣候、高濕度、潮氣重、高低溫（-50℃至+180℃）、二氧化硫、二氧化碳等惡(e)劣的戶外環境中1-20年保持工件不生銹，保持紫銅件本色光澤度、顏色等作用，耐中性鹽霧時間(NSS)≥48-800h。
二、銅飾品的前期處理使用操作
1、紫銅件的前期處理是使用水性無鉻無重金屬環保銅件除油除氧化膜增光工間防氧化四合一清洗劑。用于已除銹的銅件（紫銅、黃銅、白銅、青銅、鈹銅、銅鋁合金、電鍍銅、化學鍍銅等）的除油、除氧化膜、增光、工間防氧化前期處理中的四種性能同時實現的清洗；該產品未含有硫酸、硝酸、鹽酸，鉻離子等有害環境等物；對銅件基體沒有腐蝕。外觀為無色透明無味無雜質無酸霧液體，PH=1.5；
2、在35-40℃中將已除銹的銅件直接放入此液中浸泡30-60秒（超聲波清洗時間30秒），用清水沖洗1-2次，吹烘干水份后、就可放入銅件封閉劑池內進行封閉防變色處理；
3、銅件除銹：室溫中在銅件除油除氧化膜增光工間防氧化四合一清洗劑中浸泡30-60秒可以除油、除氧化膜、增光、工間防氧化。
4、用干燥無水份無脂棉布擦洗2-3次，每擦洗一次后，更換棉布；最好是在最后一次用棉布擦洗時，邊用≤55℃熱風吹干水份，邊用聚脂布搓擦上工作液；
5、初步除水份≤55℃烘干或熱風吹干水份5-10分鐘；
6、在環溫中浸泡在工作液內3-5秒；或用聚脂布搓擦上工作液搓擦兩道以上可耐蝕防氧化變色等。
注1：2、3工藝序號為本清洗劑工藝段；
注2：工間防氧化時間-要椐銅材種類、冬季和夏季、當地濕度三個因素來定，平均大約為2小時，最好將經清洗處理后的并已烘干水份的銅件立即、在最短的時間內放入銅件后處理防氧化變色封閉劑《紫銅件耐鹽防銹防氧化變色高透明納米液晶液》內浸泡。
